Installation Tools
Medical Facility Responsibility
Mounting onto LCD VESA Plate
It is the responsibility of the end user to ensure all aspects of the installation are covered by following the
full manual at:
http://www.amico.com/barcode-dock-mount
Installation and Adjustment Instructions
Barcode
Dock Mount
Quick Setup for BARCDHLD2-LCD
!
WARNING
No. 2 Phillips head screwdriver (not provided)
1/8" HEX key for BARCDHLD2-M (not provided)
7/16" wrench for BARCDHLD2-LCD configuration (not provided)
1.
For BARCDHLD2-LCD, slide X-MON-SHELF-ARM to desired position and tighten two H-HNUT-1420. Insert and tighten two H-1420-LNUT-NYL to
lock X-MON-SHELF-ARM in place as seen in
Figure 1.
2.
Loosely insert 2X H-PHMS-M4-12 through the top two holes of X-MON-HDL-BDY and into the monitor (not provided) as seen in
Figure 2.
3.
Slide two H-PHMS-M4-12 into the U-notches on LCD VESA plate (not provided). Insert another two H-PHMS-M4-12 into the two bottom holes of
LCD VESA plate, X-MON-HDL-BDY, and into monitor as seen in
Figure 3.
4.
Tighten four H-PHMS-M4-12 in a cross-pattern.
Figure 1
Figure 2
Figure 3
Tools
1/8" HEX key
No. 2 Phillips screwdriver
Adjustable wrench
*
Tools not provided by Amico
