Batteries & Battery Replacement
The door-window / combination sensor works with a
3.6V 2700 mAh
lithium battery
Mignon / AA size. The battery label required is
ER14505
to change that battery is that
you remove the Phillips screw of the battery cover on the underside of the sensor and pull
the cover forward. The securing screw is prescribed for class 2 sensors according to DIN
EN 50131-1. According to the regulations a battery without tool can be removed from the
sensor. If necessary, open Your window to get to the screw below the sensor. After the
battery has been removed, you see the head of the battery.
To change the battery
Remove the retaining screw from the transmitter and remove the battery inside. Then you
can insert the new battery.
First install batteries always with the flat minus pole page
at the battery bay.
Then the lid must be put back in the housing bottom. It is important
that you apply light pressure to the battery head with the lid to make sure contact is
made. Then screw in the locking screw again.
When the battery level is low, a message is sent to the control panel, the warning is
displayed on the control panel and you will receive information via SMS / E-mail
(depending on the settings in the control panel). It is recommended to check the battery
level in the sensor display once a month. A full battery starts with 3 bars in the battery
indicator, only 1 bar is displayed should an order of the batteries be prepared.
Batteries
The sensor can be operated with
ER14500
batteries instead of ER14505 disposable
batteries. It is important to ensure that a battery has a maximum capacity of 900 mAh
(disposable battery about 2700 mAh)
The battery must be charged accordingly every 4-6 months.
The charging takes place in an
external charger
, which can be ordered together with the
batteries from your dealer. It is recommended to have at least 1 battery in reserve. This
allows you to always exchange an empty battery for a charged battery immediately.
