Pairing the radio transmitter with the sirens
Make sure that the radio transmitter is connected to the lower USB socket on the left side of the
BTS transmitter and switched on via the large right button.
Now you have to train the signal of the radio transmitter in the siren.
Open the metal housing with the two screws on the bottom left and right. Now connect the siren
to the mains power and switch on "power on". Back on (switch up). Release the switch for
"Siren on".
(Switch down)
Press the black programming button on the recess in the black housing. The siren is now in
teach-in mode, as indicated by the red LED next to the programming button. Now switch the
radio transmitter on the tablet ON (red LED on the transmitter itself lights up permanently) so
that it transmit
s permanently. Please go to menu → Settings → Smart Home & Siren Control
and then to the ON button. Now you can set the time, 5 seconds are sufficient. If the transmitter
has been successfully learned, the FAS is activated.
Attention
: Protect your hearing when the siren starts.
You can switch the siren off again by switching off the radio transmitter or at the switch on the
back of the siren
Now unfold the settings for the Smart Home transmitter (small triangle on the right side) and tick
Alarm confirmation when triggered.
Only attach the Smart Home transmitter after a successful range test.
