For the motion detector with pet function, the mounting height depends on the size of the
pet, in a large dog, the sensor must be mounted higher in order to create more space.
Make sure that the sensor is not aligned with furniture, for example, a cat can jump.
If you have decided on a mounting location, remove the protective film from the magnet
holder and carefully push the sensor into the selected location. Then push the sensor to
the side of the magnetic holder and press the magnetic plate again.
If it is not possible to use the magnetic adhesive pad due to woodchip wallpaper or other
reasons, alternatively the magnetic plate can be fastened by means of a screw and
dowel. But the magnetic disk has a hole in the middle.
After mounting, leave the monitored area for at least 1 minute and then walk past
the motion detector at normal walking speed.
Pay attention to the flashing of the blue
LED, the motion detector has then already detected about 2 seconds before. If the sensor
has been tested successfully, the assembly of this sensor is finished.
Remote Control
Sensors ordered in sets are shipped already paired.
General
The middle button is factory set to outside only, but you can do that under
Settings
Sensors
Sensor 01-99
Edit
Arming, select one of your own arming
modes
