Installation
6
BOSS Scoring Bowler Terminal Consoles
Installation, Operation, Service, and Parts Manual
400-286-003 Rev. New
4. Solder 2.5 feet (76.20 cm) of #18 AWG stranded black wire (010-100-100) to 2 ¼ -
inch intercom/BT speaker (770-047-175) marked by the negative (-) sign.
5. Solder 5 feet (152 cm) of #18 AWG stranded white wire (010-100-109) to 2 ¼ -inch
intercom/BT speaker (770-047-175) marked by the positive (+) sign.
6. Locate and route the intercom PCB (286-001-066) through the speaker hole on the
keyboard plate (286-002-037).
7. Solder 2.5 feet (76.20 cm) of #18 AWG stranded red wire (010-100-102) one end to
E4 connector located on the intercom PCB and the other end attach to molex
connector located on the keyboard plate (286-002-037).
8. Solder 2.5 feet (76.20 cm) of #18 AWG stranded red wire (010-100-102) one end to
E3 connector located on the intercom PCB and the other end attach to molex
connector located on the keyboard plate (286-002-037).
9. Place the o-ring (919-100-001) onto the speaker mounting hole. This will hold the
speaker in place snuggly.
10. Route the #18 AWG stranded black wire (010-100-100) already attached to the other
end of the 2 ¼ -inch intercom/BT speaker (770-047-175) through the speaker hole
and solder to the E2 connector located on the intercom PCB.
11. Route the #18 AWG stranded white wire (010-100-109) already attached to the other
end of the 2 ¼ -inch intercom/BT speaker (770-047-175) through the speaker hole
and solder to the E1 connector located on the intercom PCB.
12. Mount the intercom PCB (286-001-066) to the keyboard plate (286-002-037) using
two #6-32 x ¼ phillips pan head screw (818-227-042).
13. Replace icon keyboard (286-001-089) from keyboard plate (286-002-037).
14. Replace the four #4-40 hex nuts (843-121-002) and faston tabs (760-022-262) from
keyboard plate (286-002-037) and close front cover on bowler terminal.
15. Set the switches on the bowler terminal board by using the switch configuration label
settings (286-001-074) located on the pedestal assembly (286-002-056). For proper
configuration, refer to the section called Switch Configuration Settings.
16. Vacuum and remove debris from around the bowler terminal area after performing
the intercom upgrade.
17. Turn power on and verify that everything is working correctly.
