© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 11
3.2
Rack Installation
The UPS and the external battery packs are designed to be rack-mounted in four post frames. The UPS and ex-
ternal battery pack use identical mounting hardware and procedures.
NOTE:
The rack-mount UPS draws air from the front. If the rack has a door on the front, make sure
that there is some clearance between the UPS vents and the rack door.
Because of the weight of these units, two people are recommended to lift and hold into position while all fasteners
are secured. Please use the supplied fasteners to attach the supplied mounting brackets to the UPS or external bat-
tery pack.
If external batteries are included in your installation, please mount them first and as low as possible. Start with the
lowest available position and work up. Your UPS should be installed last and end up on the top of all the battery
packs for proper cable routing.
ATTENTION:
Use all supplied mounting hardware on each UPS and external battery pack.
NEVER depend on lower devices to support other devices.
Included in each rack-mount carton is a rail kit. The rail kit consists of the following components:
3.2.1
Assembly Steps
Step 1:
Use four M6 screws to mount the right and left rail sliders to the two front posts of the four-post rack.
Refer to the figure directly below:
