![background image](http://html1.mh-extra.com/html/ametek/sorensen-xg/sorensen-xg_operation-manual_2931320200.webp)
Remote Operation
5-66
M370430-01 Rev B
4.
From the Hyper Terminal (or any other terminal program)
select the
Transfer>Send Text File...
5.
Navigate to and select the text file that was previously stored.
Click the Open button.
6.
Execute the program recording stop command:
:PROG:STOP
7.
Execute the readback command to verify the entire program
was transferred correctly:
PROG:READ?
8.
Set the data rate back to the original speed.
9.
Close the connection to the HyperTerminal program and
configure the connection data rate to be the original speed.
Running an Auto Sequence Program:
Once an auto sequence program has been stored, there are a few
commands that can be used to run the program. Once a program begins
running, it will continue running until completion and then repeat the
number of times specified by the repeat command. The default at power
on is to have repeat set to 1.
Commands:
*TRG
[:]INITiate[<channel>][:IMMediate]
[:]PROGram[<channel>]:STATe {?|RUN|STOP|PAUSe}
Where:
RUN
causes the program to begin execution.
STOP
causes the program to stop execution
PAUSe
causes the program to stop executing at the current
command. If a subsequent run is sent, the program will resume
executing with the next command in the program.
For Example:
:PROG:STAR
*IDN?
*IDN?
:PROG:STOP
Summary of Contents for Sorensen XG
