Ametek Sorensen Asterion DC ASM, Programming Manual

Page: 109 / 162

Asterion DC Multioutput Series
Programming Manual
10-92
M330517-01 Rev C
Command Description
SCPI
CALibrate<n>:OUTPut:VOLTage:EXTV:OFF
SET <NRf>
Sets the calibration Offset point for
voltage programming from external
voltage source
N
CALibrate<n>:OUTPut:VOLTage:EXTV:FSC
<NRf>
Sets the calibration full-scale point
for voltage programming from
external voltage source
N
CALibrate<n>:OUTPut:VOLTage:EXTI:OFF
SET <NRf>
Sets the calibration Offset point for
voltage programming from external
resistance source
N
CALibrate<n>:OUTPut:VOLTage:EXTI:FSC
<NRf>
Sets the calibration full-scale point
for voltage programming from
external resistance source
N
CALibrate<n>:OUTPut:VOLTage:MON:OFFS
ET <NRf>
Sets the calibration Offset point for
voltage monitor signal
N
CALibrate<n>:OUTPut:VOLTage:MON:FSC
<NRf>
Sets the calibration full-scale point
for voltage monitor signal
N
CALibrate<n>:OUTPut:VOLTage:PROTecti
on:DAC <NR1>
Sets the output of the output
overvoltage protection D/A
converter.
N
CALibrate<n>:UNLock <string>
Sets the non-volatile memory
available to store calibration
constants. The access string is
“6867”.
N
CALibrate<n>:STORe
Stores the calibration constants in
non-volatile memory.
N
CALibrate<n>:LOCK
Disables access to the non-volatile
memory. Prevents attempts to store
calibration values. (Issue after
CAL<n>:UNLock and
CAL<n>:STORe commands)
N
STATUS SCPI Command Subsystem
This section first presents a tree summary of the STATus commands and then provides
a tabular description.
10.12.1
STATUS SCPI Command Summary
STATus<n>
:PROTection
:CONDition?
:ENABle <NR1>
:ENABle?
:EVENt?
10.12.2
STATUS SCPI Command Reference
The letter “C” in the “SCPI” column means that the command syntax is SCPI compliant;
an “N” in the “SCPI” column means that the command syntax is not part of the SCPI
definition.