Ametek mocon Dansensor MAP Mix ProVectus, User Manual

Page: 62 / 80

60 User Guide EN Dansensor
®
MAP Mix Provectus
P/N 300862-K
11/2019
Access level
When device is switched on (after power off ) it is locked in User access level. In User access
level you have only access to a limited number of functions and is not allowed to perform
parameter setup.
To obtain full access (except “Calibration” which is for Service Technicians only) you will have
to change the device to
Supervisor access level.

To do so select Access level from the Main menu menu to display the Access level screen.
Press Enter PIN code key to open a touch screen keyboard and enter the PIN code for
Supervisor access level. From the factory the PIN code is set to “0000” .

After pressing OK you will be returned to the Main menu now displaying the additional
menus for the Supervisor access level.
For best safety and correct operation of device, you can easily return the device to User level
access to restrict access to extended menu items. To do so either press the Set user level key
in the Access level screen (will only be available in Supervisor or Service access levels) or
power the device off and on.
Change Supervisor PIN code
The Supervisor PIN code can be changed to one of your own selection:

Select General setup from the Main menu then scroll to the bottom and select the
Supervisor PIN code setup item. This brings up a touch screen keyboard.
Set level user
1
4
7
2
5
8
0
3
6
OK
9
Access level Enter access PIN code
Current access level:
User
Set level user Enter code PIN
Set level user
Access level
Current access level:
Supervisor
Enter code PIN
Set user level
1
4
7
2
5
8
0
3
6
OK
9
Enter old access PIN code