Ametek Mocon Dansensor LeakPointer 3, User Manual

Page: 96 / 100

94 User Guide EN Dansensor
®
LeakPointer 3/3 +
P/N 380064-F
06/2021
Explosive atmospheres

Using the device in any area with a potentially explosive atmosphere, such as areas where
the air contains high levels of flammable chemicals, vapours, or particles, may be
hazardous. Obey all signs and instructions.
Cleaning

Never use hard tools or abrasive materials when cleaning any part of the device.

Never use cleaning agents containing chlorinated solvents or acetic or phosphoric acid.
These constitute a health hazard and could damage the device.

Avoid getting moisture in openings.

When using compressed air for cleaning of e.g. hoses or needles, make sure that items have
been disconnected from the device and use safety goggles.
Using connectors, ports, and buttons

Never force a connector into a port or apply excessive pressure to a button, because this
may cause damage that is not covered under the warranty.

If the connector and port don’t join with reasonable ease, they probably don’t match.
Check for obstructions and make sure that the connector matches the port and that you
have positioned the connector correctly in relation to the port.
Operating/storing temperatures and humidities

The device is designed to be operated and stored in the temperature and humidity ranges
as specified in
"Mechanical specifications" on page 87 .

The device can be damaged if stored or operated outside of these ranges.

If the device has been stored in a cold location and then moved to a warmer location, at
least one hour of acclimatisation is required before switching it on.

If the device is operated in a cold and high humidity environment it is advisable to let it
heat up for 5-10 minutes after it has been switched on.
Toxic and Hazardous Substances or Elements
(For China RoHS compliance)
See table on the next page.