7 - 1
Cyclops L
Portable Thermometers
User Guide
DISPLAY PANEL MODES
7
7.1 Introduction
The LCD display panel has four basic modes of operation:
•
Measure Mode
•
Menu Mode
•
Route Mode
•
Operator Emissivity Mode
When the thermometer is switched on, an introduction screen is displayed.
After the introduction, a screen is displayed indicating the calibration status
– indicating whether the
Cyclops
is due for an annual calibration check. This
requires the correct date to be set on the Real time Clock (RTC), see Section
7.6.13. This calibration status check can also be disabled in the same sub
menu. To move on to normal Cyclops operation, hit any key.
This screen times-out automatically and is replaced by the
Measure Mode
or
Route Mode
display.
To access the
Menu Mode
, press the
(Enter/select) key on the keypad.
Note
In the event of a fault causing loss of on-board memory, an error message
will be displayed near the bottom of the screen. For a list of error codes and
their meanings, see Appendix 2
7.2 Measure Mode (Classic, Burst and Latched Trigger Operation)
When the unit is in Measure Mode, the display indicates the Peak, Continuous,
Average, and Valley temperature values simultaneously. If you have a
Cyclops 055L
, the display shows the special Meltmaster mode temperature
instead of the Average temperature.
On the side LCD display panel, the selected measurement type is displayed
larger and bolder than the three non-selected measurement types. Note that
the thermometer measures in all four measurement types continuously.
