Ametek Dycor CG1000-RTP, User Manual

Page: 35 / 96

Controller / User Interface
|
4-1
USER INTERFACE
Passwords
This menu option allows you to define a system password which limits
access to certain menu options to authorized personnel only. You can also
use this menu option to disable the password requirement. By default, the
system password is disabled. If you don’t want to enable a system pass-
word, skip this section.
If you cannot remember the correct password, call AMETEK/Dycor
and a service password will be provided so you can access the Pass-
word option and enter a new system password.
1. From the Setup key menu, select Passwords .
Enter new password
2. Enter a four digit password. To protect the identification of the pass-
word, the numbers you enter are displayed as blocks rather than as
text. You are then prompted to reenter the password to verify it.
Reenter to Verify
Reenter the password.
To later disable or change the system password, you must first enter
the old password to access this menu option, then change or disable
the password (0000 disables the password).
NOTE

NOTE
