Mobile Phone Holder
Mobile phone holder is designed to fit most phone sizes, including
many with a protective case (up to about 84mm or 3.3”). Simply pull
apart spring loaded jaws, place mobile phone in cradle and release
jaws. Holder will securely grip and hold your phone with soft grip
jaws. Position phone at virtually any angle by loosening locking nuts
on either end of the Angle Control Arm. Ball joints make positioning
easy and versatile with 360° rotation. Re-tighten locking nuts for a
secure installation.
CAUTIONS
:
1.) Use caution when installing overhead to ensure product is
securely attached.
2.) Use only the size and type of batteries specified.
3.) Always purchase the correct size and grade of battery most
suitable for the intended use.
4.) Be sure to follow the correct polarity when installing the
batteries as indicated in the
battery compartment.
5.) Reversed batteries may cause damage to the device.
6.) Do not mix alkaline, standard (Carbon-Zinc), or rechargeable
(Nickel Cadmium) batteries.
7.) Replace all batteries of a set at the same time. Do not mix old
and new batteries.
8.) Clean the battery contacts and also those of the device prior to
battery installation.
9.) Do not dispose of batteries in fire.
10.) Remove batteries if consumed or if product is to be left unused
for an extended period of time.
Where to install your GripLights
The GripLights are IP44 rated for indoor/outdoor use. It is protected
from solid objects greater than 1mm and from splashing water
from all directions. Caution: When used outdoors make sure slide
switch on Heavy Duty model is facing down. For long term outdoor
use install under eaves or other structures where GripLight is not
exposed to direct rain. When attaching to structures such as fences
or trees with Flexible Griping Tripod, be sure product is secure and
fixed firmly to keep it from swaying in the wind so it will not fall on
people. With batteries installed product is heavy and serious injury
can occur.
Your GripLights may be installed on any metallic surface such as
the underside of a car hood, metal storage cabinets, metal poles,
etc. If no metal surface is available, you can also use the Metal Plate
accessory and affix that to any non-metal surface where a screw may
be used. Be sure to use proper plastic anchors in drywall or other
softer surfaces to properly secure your GripLight.
2 Motion Sensing LED
Mobile Phone Holder Owner’s Manual
250 Boulder Dr.
Breinigsville, PA 18031
610-336-1330
www.amertac.com
Made in China / Fabriqué en
Chine / Fabricado en China
© 2019 AmerTac™
BO_TL_041_0320
GRIPLIGHT
GRIPLIGHT
TM
Mounting Instructions Options for lights and mobile
phone holder
• Use Flexible Tripod to wrap legs around
a
variety of objects or stand up on legs.
Simply attach tripod legs by screwing
into threaded hole on bottom of light or
mobile phone holder.
• Use magnets built into light or mobile
phone holder base to attach to any magnetic
metal surface or use included Metal Plate
accessory to attached to most non-metallic
surfaces. Includes a screw and plastic anchor.
Be sure Metal Plate accessory is firmly
attached to mounting surface to avoid injury or
product damage from falling.
• Position Flexible Griping Tripod legs to support product
standing independently.
Congratulations on your purchase of the Griplight portable task and worklight. It is perfect for camping, automotive, power
outage, travel, task lighting or other indoor/outdoor uses.
