Installation
2
Pump P-960
User Manual 18-1172-73 Edition AA
9
2 Installation
2.1
Unpacking
Unpack the unit and check the items against the supplied packing list.
Inspect the items for obvious damage that may have occurred during
transportation.
Keep all packing materials if onward transport of the unit is expected.
2.2
General precautions
The unit should be installed in a non-corrosive atmosphere.
The unit should be located in a place of low temperature variations,
away from heat sources, draught and direct sunlight.
The unit may be operated at normal ambient temperature in the range
4 °C to 40 °C.
2.3
Installing the pump
When installing P-960 as an accessory, refer to the Optional
Configurations User Manual for detailed instructions on how to install
the sample pump in your ÄKTAdesign system.
CAUTION!
Read the following information carefully to ensure that the
unit is installed correctly.
CAUTION!
Make sure that the sample pump is installed and operated
at an upright position.
18117273aa.book Page 9 Thursday, July 3, 2003 5:13 PM