INST-EAI Rev 2
Confirm EverAlert Integrator Installation
a. Click on Displays in the menu bar below the DISPLAY LIST.
b. The list of Integrator(s) assigned to the site will display under Integrator menu bar. A green
status icon next to the Integrator title indicates the Integrator is communicating with the inCloud
Management Portal. A red status indicates a lack of communication between the Integrator and the
inCloud Management Portal. This means the Integrator may not be installed correctly or there is a
network ssue. Reference the Installation Manual for troubleshooting.
c. The icons under INPUT 1 and INPUT 2 should be green unless an Alarm is triggered. The icon for
the triggered input will be red until the Alarm is cleared.
EverAlert Integrator Status Indication
The status LED on the Integrator indicates the
connection status and verifies the activation status of the
INPUT switches.
• RED: Power on, no connection
• ORANGE: IP received
• GREEN: Integrator connected to Portal
• FLASHING GREEN (1 sec interval): INPUT 1 ON
• FLASHING GREEN (3 sec interval): INPUT 2 ON
• FLASHING GREEN (5 sec interval): INPUT 1 ON
and INPUT 2 ON
Pre-Installation
1. Determine a mounting location that is near intended monitoring equipment.
2. An Ethernet connection with internet access is required to communicate with the EverAlert
Management Portal.
• Ethernet 10/100 Base-T
• DHCP enabled network is required
3.
CAUTION:
If the Integrator will be connected to Life Safety equipment such as a fire alarm panel, it is
recommended that these connections be made by the licensed installer of the system.
Unpack the box
Remove the components from the box. Save the packing materials in case you need them later.
Check the contents
Your package contains:
• Quick Start Guide
• EverAlert Integrator
• Power Supply AC-9VDC Wall Plug
• 4 ea. Rubber Feet
9
10
EverAlert
®
Integrator Start Installation Guide
Please read this first!
If this is your first installation or you have questions at any time during this process, please call
American Time toll free at
800-328-8996
.
phone:
800-328-8996
online:
fax:
800-789-1882
mail:
140 3rd St. So.; PO Box 707, Dassel, MN 55325-0707
1
2
3
Integrator Output Function
The Integrator Output can activate secondary low-powered devices, such as a
strobe or alarm (or a larger secondary relay for devices requiring more power),
when one of the Inputs or a specified Alarm/Weather Alert is activated. The Output
relay is capable of supporting voltage up to 60VDC or 125VAC, with a maximum
switched current and carrying current of 1A.
DO NOT EXCEED THIS VOLTAGE
AND CURRENT.
If greater voltage/current is required for the connected device, the
Output relay can be used to command a larger relay.
The wiring shown in Step 5 will keep the secondary device inactive until the
associated Input is activated. Switching the wiring from the Normally Closed
(1) contact to the Normally Open (3) contact will reverse the Output function,
meaning the secondary device will be active until the associated Input and/or
Alarm is activated.
11
1. Normally Closed
2. Common
3. Normally Open
