*Wrench
Certified to comply with ANSI A112.18.1
Recommended Tools
*Supplied with Fitting
*Hex key
SPOUT RECESS
Turn off hot and cold water
supplies before beginning.
CAUTION
1
2
Assemble RUBBER WASHER
(4)
and BRASS WASHER
(5)
and
LOCKNUT
(6)
onto SPOUT SHANK
(3)
. Align SPOUT ASSEMBLY
and from underside of ledge secure SPOUT ASSEMBLY into
position with LOCKNUT
(6)
.
SPOUT ASSEMBLY
PREPARE TUBE AND TEE ASSEMBLY
4
2
3
1
3
4
1
2
4
5
Prepare TUBE and TEE ASSEMBLY
(1)
to fit each VALVE
(2)
.
Distance between valves should be between 10-1/2" and 12"
(center to center). If necessary, cut and/or bend TUBING
carefully. Make sure tube bend is close to the TEE
(1)
so
that it will not effect the compression joint at the
VALVE CONNECTION.
ADJ. 10-1/2 TO 12
6
5
Flat Blade Screwdriver
Adjustable Wrench
Slip Jaw Pliers
MOUNTING
SURFACE
VALVE inlets are 3/4-inch NPT male.
NOTE
ROUGHING-IN DIMENSIONS
MOUNTING
SURFACE
DECK-MOUNT BATH FILLER
Installation
Instructions
7186.900
7186.901
Install RING WASHER
(1)
into SPOUT recess. Check that O-RING
(2)
on end of SPOUT SHANK
(3)
is in place. Insert SPOUT SHANK
(3)
through center hole on mounting surface.
FLUENT™
3
M 9 6 5 6 2 3
Remove COUPLING NUT
(3)
and FERRULE
(4)
from each
VALVE
(2)
and slide onto TUBING
(5)
.
MOUNTING
SURFACE
165mm to 305mm
(ADJ. 6-1/2 TO 12)
38mm
(1-1/2" MAX.)
32mm
(1-1/4" MAX.)
31mm
(1-3/16" DIA.)
76mm
(3")
40mm
(1-5/8")
DIA.
(
H
)
(
C
)
29mm
(1-1/8" DIA.)
208mm
(8-3/16")
305mm
(12" MAX)
53mm
(2-1/16")
27mm
(1-1/16" DIA.)
3/4-14 MALE
N.P.T. INLETS
93mm
(3-5/8")
140mm
(5-3/8")
219mm
(8-5/8")
250mm
(9-3/4")
199mm
(7-7/8")
SPOUT
ASSEMBLY
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
