Connect water supply to FAUCET with 1/2" IPS FLEXIBLE
SUPPLIES
(1)
or 3/8" O.D. BULL-NOSE RISERS
(2)
.
Use adjustable wrench to tighten connections. Do not over
tighten. Be careful not to kink copper supply when bending.
Use tubing cutter to cut to proper length.
MAKE WATER SUPPLY CONNECTIONS AND TEST
INSTALLED FITTING
M968493 REV.1.6 (8/19)
Plumbers' Putty or Caulking
Adjustable Wrench
Channel Locks
Recommended Tools
1
2
INSTALL FAUCET
1340.225
1340.227
Certified to comply with ANSI A112.18.1
Thank you for selecting American-Standard...the
benchmark of fine quality for over 140 years.
To ensure that your installation proceeds
smoothly--please read these instructions carefully
before you begin.
Installation
Instructions
METERING
Centerset Faucets
2
3
4
5
1
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE
PURCHASED SEPARATELY.
Insert faucet SHANKS through holes of SINK or
MOUNTING SURFACE.
Install GASKET
(2)
, FRICTION WASHER (3), DEEP
WASHER
(4)
and LOCK NUT
(5)
. onto SHANKS
(6)
.
Tighten LOCK NUTS
(5)
firmly to secure FAUCET
(1)
.
Apply a bead of PUTTY along the edge of the
underside of the FAUCET
(1)
.
SINK OR
MOUNTING
SURFACE
PUTTY
SHANK
Turn off hot and cold water supplies before beginning.
CAUTION
1340.225
1340.227
COUPLING
NUT
1
2
2.5mm Hex Wrench
Hook
Tubing Cutter
Turn on water supplies and check connections for leaks.
Remove AERATOR
(3)
with KEY
(4)
supplied.
Operate HOT and COLD HANDLES by pressing down on
HANDLES. Both Hot and Cold handles are set for approximately
8 second operating cycles.
Replace AERATOR
(3)
.
TEST INSTALLED FITTING
PRESS HANDLE
DOWN TO
OPERATE
3
4
WATER SUPPLIES
