background image

Recommended Tools

& Materials

Phillips Screwdriver
Basin Wrench
Putty Knife
Drill

Hacksaw
Pipe Wrench
Channel Lock Pliers
Adjustable Wrench

1A

2

3

Drill a clearance hole inside the 
perimeter line of the template.

Cut opening around the 
perimeter of the template.

Perimeter
of template

Perimeter
of template

730687-100

Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To 
help insure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, 
review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

1B

Using the template provided, locate the position of the sink. Provide proper 
clearance under the countertop for the fauce t supply lines, drain assembly and 
the structural parts of the cabinet.

NOTE: If replacing an existing sink be certain to shut off water supply before 
removing old sink.

Mount the faucet and drain 
assembly (not included) on 
the sink following the 
manufacturer's instructions. 
Be certain to apply a bead 
of sealing putty on the 
underside of the drain (Part 
"A") in order to ensure a 
watertight seal between the 
sink and drain. Remove 
excess putty after installing 
drain on sink.

OBSERVE LOCAL PLUMBING AND BUILDING CODES

FOR USE WITH:

0660 LOFT
0670 MORNING
0680 PETAL

Installation
Instructions

NOTE: For Wallmount or 
Countertop faucets, drill faucet 
holes according to 
manufacturer's instructions.

A

Using the template as a guide, locate the 
faucet hole on the countertop. Allow 1" 
minimum clearance between:

• the sink and faucet spout
• the sink and end of faucet handles
• the backsplash and faucet spout and handles

Use the faucet installation instructions for 
required clearances.

Countertop faucet installations:

Insure sufficient spout overhang into 
the sink. See manufacturer's 
installation instructions and roughing-
in notes for minimum spout lengths.

Wall-mount faucet installations:

OUTSIDE
EDGE OF

SINK

CUT-OUT
LINE

1" (25mm)
 MIN.

BACKSPLASH

A

ABOVE COUNTER SINK

Tubing Cutter
Regular Screwdriver
Plumbers' Putty or Caulking
Tape Measure

© American Standard Inc. 2004

Reviews: