American Megatrends Super Voyager VLB-III, User Manual, Page: 38 / 138

Chapter 2 Installation
48
Step 2 Set Switch and Jumper Options,
Continued
J39 Password LED Enable
J39 is a three-pin berg that enables the Password LED. The end user must enter the correct system password
if the Password LED is blinking. If the password LED blinks, the system has experienced no system activity
during the length of time specified in Power Management Setup. The WinBIOS system password feature
and WinBIOS Power Management feature must be enabled before the Password LED will blink when the
correct system password must be entered by the end user.
J4 Pin Settings LED selected
Short Pins 1-2 Front panel power LED is Password
LED.
(Factory setting) .
Short Pins 2-3 Separate Password LED using J38.
J16 Local Bus ID3 Select
J16 is a three-pin single-inline berg. In normal operation, pins 1-2 are shorted when running Local Bus
Adapter Cards at 20, 25, or 33 MHz. The factory setting depends on the motherboard frequency. Short pins
2-3 if running Local Bus Adapter Cards at speeds higher than 33 MHz. J16 is shown below. See the graphic
on page 32 for the location.