American Magnetics 430, Installation, Operation And Maintenance Instructions, Page: 159 / 254

R
EV
9 143
A
MERICAN
M
AGNETICS
, I
NC
. R
EMOTE
I
NTERFACE
R
EFERENCE
: RS-232 C
ONFIGURATION
RS-232 C
ONFIGURATION
The Model 430 Programmer uses the following
fixed
parameters related
to the RS-232 interface:
•
Baud Rate
: 115200
•
Parity:
No Parity
•
Data Bits
: 8 Data Bits
•
Number of Start Bits
: 1 bit
•
Number of Stop Bits
: 1 bit
•
Flow Control
: Hardware (RTS/CTS)
S
ERIAL
C
ONNECTOR
An IBM-compatible computer’s serial port can be directly connected to
the Model 430 Programmer via a standard DB9-female-to-DB9-female
null modem serial cable. Refer to your computer’s documentation to
determine which serial ports are available on your computer and the
required connector type.
The Model 430 Programmer is classified as a DTE (Data Terminal
Equipment) device. It uses the standard DB9 male connector and
identical pinout used on IBM-compatible computers. The RS-232
connector pinout for the Model 430 Programmer is fully documented on
page 204 in the
Appendix
.
T
ERMINATION
C
HARACTERS
All commands and queries are transmitted and received as ASCII values
and are case insensitive. The Model 430 Programmer always transmits
<CR><LF>
(a
carriage return
followed by a
linefeed
) at the end of an
RS-232 transmission. The Model 430 Programmer can accept
<CR>
,
<LF>
,
<CR><LF>
, or
<LF><CR>,
or a semicolon ( ; ) as termination
characters from an external computer.
E
THERNET
C
ONFIGURATION
The Model 430 Programmer provides a 10/100Base-T Ethernet interface
as a standard feature. It complies with the IEEE 802.3u 100Base-TX and
802.3 10Base-T standards.
The Model 430 Programmer allows its IP address, subnet mask and
gateway IP address to be assigned either statically or dynamically. To
make these values static and assign them manually, set IP Address
Assignment to Static (see page 106) and then set the values using the