Installation
5
Installation
Compressor Installation
Component Installation
This section pertains to the installation of the air compressor, PTO, pump and
other related items. The instructions are intended as a guide to assist you with
particular installation. These instructions will provide only general information.
Torque and Procedure Chart
Pulsation Chamber Assembly
Torque Value: 31 FT. LBS.
Procedure: See Head Installation Procedure Section
Head Assembly
Torque Value: 31 FT. LBS.
Procedure: Assemble head on the cylinder with head bolts started only, not tight. Snug
(6) head bolts to light torque. Tighten (6) head bolts to 31 Ft-lbs. torque, doing the (2)
long center bolts first and the (4) short bolts last. After five hours of use re-torque bolts to
31 Ft-lbs.
Cylinder Assembly
Torque Value: 20 FT. LBS.
Procedure: After assembling cylinder over pistons and setting into place, tighten (6) cap
screws finger tight. In a criss-cross pattern, tighten bolts evenly so all bolts are hand snug.
Again in a criss-cross pattern torque each bolt to 20 Ft-lbs., checking each bolt twice.
After five hours of use, re-torque bolts to 20 Ft-lbs.
Connecting Rod Assembly
Torque Value: 18 FT. LBS.
Procedure: Assemble rod onto the crankshaft taking care to align the machined
surfaces together and tighten cap screws finger tight. Tighten bolts until hand tight and
torque to 18 Ft-lbs. Check twice the torque reading before final assembly of the
cylinders.
