MEGAPOWER 48 / ADTTE
8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE
7 of 43
General User Tasks
The following tasks can be performed regardless
of the keyboard lock setting.
•
Log On
•
Log Off
Logging On
If
UC
appears in the
Camera
display of your
keyboard,
User Codes
and
Passcodes
have
been implemented at your facility. You must log
on before attempting to use the system.
Note:
MP48 provides a default passcode for user
1.
The default passcode is 914365.
To prevent
unauthorized use of the system, this passcode
should be changed. See
1.
UC
(User Code) appears on the LCD.
2. Enter the
User Code
(1-64). Press
User
.
3.
PSC
(Passcode) appears on the LCD.
4. Enter the passcode (up to 6 digits). Press
User
.
Once logged on, you can begin performing other
tasks.
Logging Off
When the MP48 system is not in use, you should
log off the system. This will ensure that
unauthorized users cannot control your system.
1. Enter
99
.
2. Press
F1
(located to the left of the LCD
display.
STS MON CAM 99
005
168
-L
F
1
F
2
3.
UC
(User Code) appears on the LCD to
indicate successful log off.
Working in Keyboard Lock
Mode
STS MON CAM 1234
005
168
-L
When the keyboard is in the
Lock mode
, the
following MP48 tasks can be performed.
Table 2: Operate Mode Tasks
Task Page
Note:
These tasks may also be performed using
programming mode. However, users without
programming privileges are limited to performing
only these tasks.
Enter
99
then press
F1
to log off.
