MEGAPOWER 48 / ADTTE
8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE
43 of 43
To configure an alarm contact table:
1. Move the cursor to the
Table
position. Enter the
alarm contact table number (
1-10
) if the table will
be used with event timers.
Note:
If the default table is to be used, do not
enter table number.
2. Associate alarms to monitors.
a. Position the cursor at the cross point of the
Monitor
column and
Alarm
row.
b. Press
Enter
(
Shot
) to toggle the setting.
N
No association between the alarm
contact and monitor.
Y
Alarm association between the alarm
contact and monitor.
c. When the correct auxiliary state is displayed
in the number and state rows, press
Next
.
d. Repeat steps 2a-2c for each association you
want to make.
3. When finished making changes, press
Exit
(
Pattern
) to return to the previous menu.
Declarations
Thank you for using American Dynamics products. We support
our products through an extensive and worldwide network of
dealers. The dealer, through whom you originally purchased
this product, is your point of contact if you have a need for
service or support. Our dealers are fully empowered to provide
the very best in customer service and support. Dealers should
contact American Dynamics at (800) 507-6268 or
(561) 912-6259 or on the web at www.americandynamics.net.
WARRANTY DISCLAIMER:
Sensormatic Electronics
Corporation makes no representation or warranty with respect
to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular
purpose.
NOTICE:
The information in this manual was current when
published. The manufacturer reserves the right to revise and
improve its products. All specifications are therefore subject to
change without notice.
LIMITED RIGHTS NOTICE:
For units of the Department of
Defense, all documentation and manuals were developed at
private expense and no part of it was developed using
Government Funds. The restrictions governing the use and
disclosure of technical data marked with this legend are set
forth in the definition of “limited rights” in paragraph (a) (15)
of the clause of DFARS 252.227.7013. Unpublished - rights
reserved under the Copyright Laws of the United States.
TRADEMARK NOTICE:
American Dynamics
and
Sensormatic
are trademarks or registered trademarks of
Sensormatic Electronics Corporation. Other product names
mentioned herein may be trademarks or registered trademarks
of Sensormatic or other companies.
COPYRIGHT:
Under copyright laws, the contents of this
manual may not be copied, photocopied, reproduced, translated
or reduced to any electronic medium or machine-readable form,
in whole or in part, without prior written consent of
Sensormatic Electronics.
BSL 07/2004