American Dynamics ADTTE, Operation And Programming Manual, Page: 18 / 43

MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE
18 of 43
To set the date format from the keyboard:
Enter a date format commands.
Command Function
21 - F2 Sets MM-DD-YY format
22 - F2 Sets DD-MM-YY format
23 - F2 Sets YY-MM-DD format
24 - F2 Toggle through date formats
Note: The default date display format is MM-DD-YY .
Adjusting Text Display Position
IMPORTANT! This procedure applies to monitors
with on-screen text displayed using Format 1
(Figure 5). On-screen text cannot be adjusted on
monitors using Format 2 (Figure 6).
Note: Verify that the keyboard is in programming
mode before performing this task. See Unlock/Lock
the Keyboard on page 14.
To adjust the text home positioning:
1. Select the monitor requiring text display
adjustment.
2. Enter 50 and press F2 . This enables the Tracker
Ball for text positioning to the "home" position.
3. Move the Tracker Ball to adjust the positioning of
the text overlay
4. Enter 51 and press F2 when finished.
Detecting Camera Video Loss
The MP48 system has built-in video loss detection.
Video loss is determined by the absence of a video
sync signal at any of the 48 video inputs on the
patch panel. Loss of the sync signal would occur if a
camera is malfunctioning, disconnected, or if the
camera cable is cut.
IMPORTANT! If video loss detection is enabled for
any video input, video output 16 cannot be used for
switching. Video output 16 is used to sample video
when video loss detection is enabled.
Note: Verify that the keyboard is in programming
mode before performing this task. See Unlock/Lock
the Keyboard on page 14.
To set the video loss detection mode:
1. Select or hold the desired camera whose video
loss detection you want to change.
2. Enter video loss detection command.
Table 7: Video Loss Detection Commands
Command Function
100 - F2 Disables video loss detection for the
camera.
101 - F2 Enables sync loss detection ( SYNC
ONLY ) for the camera.
105 - F2 Enables automatic video loss
detection for the camera.
106 - F2 Enables automatic video loss
detection for all system cameras.
108 - F2
Clears video loss settings for all
cameras.
111 - F2 Prints the current video loss
detection mode of the selected
camera.
112 - F2 Prints the current video loss
detection mode of all system
cameras.