American Dynamics ADTT16E Touch Tracker, Installation Instructions Manual

Page: 5 / 6

ADTT16E TOUCH TRACKER CONTROLLER WITH INTELLEX 8000-2637-02, REV. C
INSTALLATION INSTRUCTIONS
5 of 6
Calibrating the Tracker Ball
1. Press Menu . The Calibration menu option
appears on the first line.
2. Press the left zoom/focus button (line 1) to
select the
Calibration
menu option.
3. Follow the instructions on the LCD screen.
4. Press
Menu to exit.
If you do not follow each instruction on the
screen, the dome may not function properly.
Re-calibrate the Tracker Ball if the dome does
not pan or tilt properly.
Calibration is only for
the ADTT16E Touch Tracker.
Configuring Devices
1. Press Menu .
2. Using the Tracker Ball, scroll down to
Config
Devices
.
3. Press the left zoom/focus button (line 1) or right
zoom/focus button (line 2) to select the
Config
Devices
menu option.
4. Press Next to step to the device configuration
for this installation.
5. Press Menu to select the device configuration
and exit.
Resetting a Dome
1. Use the number buttons to select the dome to
reset, then press Cam .
2. Press Menu .
3. Using the Tracker Ball, scroll down to
Reset
Dome
.
4. Press the left zoom/focus button (line 1) or right
zoom/focus button (line 2) to select the
Reset
Dome
menu option.
The ADTT16E Touch Tracker sends a request
to the selected dome to reboot. After a brief
delay, the controller returns to Camera Control
Mode.
Toggling between Zoom
and Focus
1. Press Menu .
2. Using the Tracker Ball, scroll down to
Tog Zoom/Focus
.
3. Press the left zoom/focus button (line 1) or right
zoom/focus button (line 2) to select the
Tog Zoom/Focus menu option.
4. Press Next to switch the zoom and focus
functions between the right and left buttons.
5. Press Menu to exit.
Adjusting V-Phase
1. Press Menu .
2. Using the Tracker Ball, scroll down to Adjust
V-Phase .
3. Press the left zoom/focus button (line 1) or right
zoom/focus button (line 2) to select the
Adjust
V-Phase
menu option.
4. Press Next or Previous to observe V-Phase
through the oscilloscope or Fluke scope.
5. Press Menu to exit.
Off-line domes or fixed cameras will generate a
warning beep and disallow use of the V-Phase
utility.