American Dynamics ADCI625-P221, Configuration And User'S Manual

Page: 61 / 142

Programs Menu
5-51
5
• Unmount the MicroSD Card for Removal - Use this procedure when you are unable to access
the power supply to the camera.
Note
If the Illustra 625 PTZ Camera is being used with the Outdoor Housing Assembly or Indoor
Housing Assembly, refer to the Quick Reference Guide supplied with the product for details on
how to remove the housing assembly and gain access to the camera.
Procedure 5-12 Remove the MicroSD Card by powering down the camera
Step Action
1
Turn off the Illustra 625 PTZ Camera by disconnecting the power supply.
2
Remove the MicroSD card from the camera.
Note
AVI clips will not be available on the camera until the MicroSD card has been
inserted and the camera rebooted.
3
Apply power to the Illustra 625 PTZ Camera.
When the camera is restarted it checks its functionality by performing a homing routine
during which the camera pans and then either goes to the start point of the ‘apple peel’
pattern or if powered up once before, to the last position in memory. Once the camera
stops, it is online and ready to be accessed and controlled.
- End -
Procedure 5-13 Unmount the MicroSD Card for Removal
Step Action
1
Select
Alarm
from the
Programs
menu.
The Alarm Summary tab displays.
When a MicroSD card has been inserted the Unmount SD card button will be displayed.
This will only be displayed on the GUI when a MicroSD card is inserted.
2
Select
Unmount SD card
to prepare the MicroSD card for removal.
You will be prompted to confirm the unmounting.
3
Select
OK
to confirm.
Or
Select
Cancel
.