7
Installation and Operation Guide
WARNING
At close range, infrared light can seriously damage a person's vision. Install this illuminator with
a minimum safety zone of 1.22m ( 4 ft. ) between the illuminator and the closest possible human
contact.
Note: 1.22M ( 4 FT. ) IS THE ACTUAL MEASUREMENT OF THE STRENGTH OF THE IR
ILLUMINATORS THAT ARE BEING USED.
Note: CAMERA STARTS UP IN BLACK & WHITE BECAUSE THE IR ILLUMINATOR IS
DISCONNECTED.
For safety reasons, the IR Illuminator is disconnected at the factory. If the IR Illuminator were to
accidentally trigger during install, it may pose a hazard to those within 4 feet. Once the camera is
installed, reconnect the power lead (see manual). Ensure that you do not cover the photo cell (see
manual) after power is reconnected as that may trigger the IR illuminator.
SERVICE WARNING
DO NOT LOOK DIRECTLY INTO AN OPERATONAL IR ILLUMINATOR.
Since IR light is invisible to the human eye, the only method of verifying a malfunctioning IR
illuminator is to observe the picture at the video output location.
SAFETY PRECAUTIONS
All the following safety and operational instructions to prevent harm or injury to the operator(s) or
other persons should be read carefully before the unit is activated.
WARNING
To prevent fire or shock hazard, avoid exposing this unit to rain or moisture.
Do not block ventilation openings.
Do not place anything on top of the unit that might spill or fall into it.
Do not attempt to service this unit yourself, as opening or removing covers may
expose you to dangerous voltage or other hazards. Please refer all servicing to your
distributor / retailer.
Do not use liquid cleaners or aerosols for cleaning.
To prevent fire or electric shock, do not overload wall outlets or extension cord.
PoE warning: If the PoE injector is used instead of the supplied power adaptor, all of
the wiring to and from the injector must be routed/ installed inside a building/ plant
and never routed/ installed outside of the building/ plant.
Please only select a power adapter or power certified by UL and marked at 24Vac /
60 Hz, minimum 1A, class 2 or LPS.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
