Contents - 1 Elevator Camera Housing and 1 Allen Wrench
Description
The 1305 Elevator Camera Housing is composed of a 2-piece housing. The rear piece is held to the front with two allen screws.
Locating and Mounting of Camera Housing
1. Select an appropriate location. Make sure no obstructions or obstacles exist around the selected site.
2. Measure the mounting area for the camera housing.
3. Securely attach the camera within the rear housing piece.
3. Securely attach the rear housing piece to the selected area.
4. Attach the front housing piece to the rear piece and secure the two pieces together with the two supplied allen screws.
Note: These installation instructions are intended only as a recommendation to qualified personnel installing this housing. Use these
installation instructions as a guideline. These instructions are not to be construed as the only means of installation that can be
used. It is recommended that the purchaser of this be cognizant of local regulations regarding safety, electrical, or structural
requirements.
AD1305
Elevator Camera Housing
Installation Instructions
IF YOU ENCOUNTER ANY PROBLEMS
OPERATING THIS UNIT, OR NEED ASSISTANCE,
CALL OUR TECHNICAL SUPPORT CENTER
within the United States 1-800-442-2225
outside the United States (914) 365-5812
AMERICAN DYNAMICS
10 Corporate Drive
Orangeburg, New York 10962
Business (914) 365-1000
Technical Support: (800) 442-2225
FAX: 914-365-1007
OP1305A
February 1994
Printed in USA
Information furnished by AMERICAN DYNAMICS is believed to be accurate and reliable. However, no responsibility is assumed by AMERICAN
DYNAMICS for its use; nor for any infringements of other rights of third parties which may result from its user. No license is granted by
implications or otherwise under any patent or patent rights of AMERICAN DYNAMICS.
Copyright 1994 by American Dynamics. All rights reserved.
