20
Each dryer
should be
connected to an independently protected branch circuit. The dryer
must be
connected
with copper wire only.
DO NOT use aluminum wire, which could cause a fire hazard.
The copper
conductor wire or cable
must be
of proper ampacity and insulation in accordance with electric codes for
making
ALL
service connections.
NOTE
: The use of aluminum wire will VOID THE WARRANTY.
IMPORTANT
:
Wiring diagrams are affixed to the inside at the top front control door and to the rear
upper back guard or panel.
2. Electrical Service Specifications
IMPORTANT
: The dryer
must be
connected to the electric supply shown on the data label that is
affixed to the left side panel/wall area behind the control door. In the case of 208
VAC or 240 VAC, the supply voltage
must match
the electric service specifications
of the data label
exactly
.
IMPORTANT
: The wire size
must be
properly sized to handle the related current.
WARNING
: 208 VAC and 240 VAC
ARE
NOT
THE
SAME.
Any damage done to dryer
components due to improper voltage connections will automatically VOID THE
WARRANTY.
NOTE
:
ADC
reserves the right to make changes in specifications at any time without notice or
obligation.
MLG-96D
ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER)*
SERVICE
VOLTAGE
PHASE
WIRE
SERVICE
MINIMUM
WIRE SIZE
APPROX.
AMP DRAW
CIRCUIT
BREAKER
60 Hz
50 Hz
60 Hz
50 Hz
208
3ø
3/4
* *
13.5
--
2 5
--
240
3ø
3
* *
12.5
--
2 5
--
380-400
3ø
3/4
* *
--
6.9
--
15
416
3ø
3/4
* *
--
6.6
--
15
460/480
3ø
3/4
* *
6.8
--
15
--
*
Contact factory for information not listed.
** AWG Stranded Wire Type ... size wire as per National Electrical Code or local codes.
