Fuse Replacement:
Disconnect from the main power supply. Insert a
standard flat head screw driver in to the fuse holder housing as illus-
trated in figure two. Turn the screwdriver in counter-clockwise direction
to remove the fuse holder. Remove the old fuse and discard it, replace
the fuse with the same type. Insert the fuse back into it’s housing.
If you continue to blow fuses, STOP using the unit. Returning the unit
for servicing. Continuing to use the unit may cause serious damage.
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
technician.
Use a flat head screwdriver to
remove the fuse holder
©
American DJ Supply
®
- www.americandj.com - RotoPod™ Instruction Manual Page 5
©
American DJ Supply
®
- www.americandj.com - RotoPod™ Instruction Manual Page 6
RotoPod™
Lamp Replacement
RotoPod™
Fuse Replacement
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
®
technician. Replace
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If after replacing the lamp you continue to blow lamps,
STOP using the unit. Contact customer support for further instruc-
tions, you may have to return the unit for servicing. Continuing to use
the unit may cause serious damage.
Lamp Replacement:
Disconnect from the main power supply. Be
sure the unit has had ample time to cool before attempting to replace
the lamp. On the front of the unit there is a single thumb screw. Remove
the thumb screw and pull back the front case housing. The housing is
hinged which allows it to pull back without being removed. Remove
the old lamp from the socket assembly. Carefully install the new lamp,
be sure to follow all the installation guide lines that are included with
your new lamp. Close the front cover and replace the thumb screw.
Trouble Shooting:
Listed below are a few common problems that you
may encounter, with solutions.
No light output from the unit;
1. Be sure you have connected your unit into a wall outlet with a
matching power supply.
2. Be sure the external fuse has not blown. The fuse is located on the
rear panel.
3. Remove the lamp cover and be sure the lamp is seated in the
socket properly. Occasionally lamps become loose during ship-
ping, be sure the lamp is push in to the socket completely.
4. Be sure the lamp is good.
RotoPod™
Trouble Shooting
Remove the thumb screw on the front of the unit as illustrated below.
Remove the lamp from the socket and insert a new one as illustrated above.
