Pinspot LED RC SPECIFICATIONS:
LED:
3W
Working Position:
Any safe working position
Power:
Rechargable Battery &
Power
Adapter
(100~240V,
50/60Hz)
Battery Life:
7 Hours
Power Consumption: 4.5W
Weight:
2lbs./ 1Kgs.
Dimensions:
6.5”(L) x 4”(W) x 6”(H)
166 x 98 x 152mm
Warranty: 3 Year (1095 days)
Unpacking: Thank you for purchasing the Pinspot LED RC by American DJ®. Every Pinspot LED RC
has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the
shipping carton for damage that may have occurred during shipping. If the carton appears to be dam-
aged, carefully inspect your fixture for any damage and be sure all accessories necessary to operate
the unit has arrived intact. In the case damage has been found or parts are missing, please contact our
toll free customer support number for further instructions. Do not return this unit to your dealer without
first contacting customer support.
Introduction: The Pinspot LED RC is part of American DJ’s continuing pursuit for creating high qual-
ity affordable fixtures. The Pinspot LED RC is a simple, small rechargeable battery powered LED light.
This pinspot is light weight and compact which makes it a great piece for mobile DJ’s, architectural
lighting, or ligting effect. The LEDs located on the rear of the unit let you know the current status of
the battery. A lit green LED means that the unit is fully charged, while a yellow lit LED means that the
unit is dead or going to die soon. NOTE: When the Yellow indicator starts blinking or is lit, please
stop using the unit, and start charging it. If you let the batteries die completely, recharging dead
batteries is very hard on the unit and will take some time.
Battery Recharge: To recharge the battery, plug the charger into the back of the unit and plug the other
end into a matching power supply. Put the switch located on the rear of the unit into the “RECHARGE”
position. When the Red LED is lit, this means the unit is charging.
Lens Change: The Pinspot LED RC comes with a standard 12 degree lens already attached. Included
in the box is an optional 6 degree lens. To switch lenses simply remove the retainer ring in front of the
current lens, carefully remove the lens, and attach the 6 degree lens. Replace the retainer ring and the
switch is complete.
