This model is used as either a 4CH. DMX chase controller or a DMX dimmer pack. It has two operating modes consisting of DMX
and MASTER modes, which allows to receive and send DMX signals. In DMX mode, it features 4 channel individual DMX address
setting. In MASTER mode, it is incorporated with 6 operating modes, MANUAL DIMMER, MANUAL PROGRAM, AUTO PROGRAM,
HOLD SOUND, PROG SOUND and AUTO SOUND. In addition, multiple units can be connected to be used together, one as a DMX
dimmer pack and the others as chase controllers. Also, STAND BY, FULL ON and PREHEAT functions are incorporated with this unit.
Before operating this unit, please read this manual thoroughly.This manual will guide you through all functions step by step.
OPERATION MANUAL
INTRODUCTION:
TECHNICAL SPECIFICATIONS:
PRODUCT INSTRUCTION:
POWER INPUT
........................................................................................................................................ AC 120V~60Hz, 20A
CHANNEL OUTPUT
............................................................................................................................ 5A /CH., Total 20A max.
FUSE
.......................................................................................................................................................... F5A 250V 5x20mm
DIMENSIONS
.................................................................................................................................................. 1308x80x74mm
WEIGHT
.......................................................................................................................................................................... 4.0Kg
OPERATING CONDITIONS
........................................................................................................... TEMPERATURE: 0--50
°
C
RELATIVE HUMIDITY:
£
85%
A. DMX mode
When the DMX indicator is on, this unit is used as a DMX dimmer pack.
1. BUTTONS 1, 2, 3 and 4
Press any one of these 4 buttons, corresponding indicator will blink, and the DMX address of corresponding
channel will appear in DISPLAY screen. Press UP or DOWN button to select desired DMX address followed
by pressing corresponding channel button, corresponding indicator is off indicating information of entry is
confirmed. then the information in DISPLAYscreen returns to initial condition..
2. UP BUTTON
3. DOWN BUTTON
6. F+MODE BUTTONS
7. F+PRESET BUTTONS
8. F+SIGNAL SELECT BUTTONS
Press to select operating mode from
DMX
to
MASTER
mode, and the DISPLAY will show OUT.
Press to select available parameter information used with UP and DOWN buttons.
This function is effective only in
MASTER
mode.
5. F+D/S BUTTONS
(Press
F
and
D/S
buttons at a time.)
Press to select CRO or NOR.
NOTE: NOR refers to 0-100% dimming.
CRO denotes only FULL ON and STAND BY are available.When dimming level is greater than 50%,
FULL ON is activated, otherwise, STAND BY is effective.
4. F+ BUTTONS
(Press
F
and buttons at a time.)
Press to select L-- or R--.
NOTE: L-- refers to data information of CH.1,CH.2, CH.3 and CH.4 corresponding to 1, 2, 3 and 4 output.
R-- refers to data information of CH.1, CH.2, CH.3 and CH.4 corresponding to 4, 3, 2 and 1 output.
Press to decrease the display value.
Press to increase the display value.
PARAMETER
FUNCTION
24-004-0206
Rev 2.0
American DJ
R
Bar-T-Cue
F00-F99
FADE TIME(0-10S)
DIMMER(0-100%)
PRESET MINIMUM DIMMING LEVEL(0-25%)
E00-E25
00- FF
P
P
