36
4.2 Running AMEC AIS Viewer
By following the steps below, user may start the AIS Viewer in a very short time after finishing all
the installation:
Step 1:
Click on the AMEC AIS Viewer program.
Please select Manual or Auto for serial port and baud rate setting. Click on
to connect with
the desired serial port and baud rate. (Refer to Figure 4-2-1).
Auto:
the system will identify and show the serial port number and baud rate
automatically.
Manual:
select appropriate serial port and baud rate manually. If you can‟t find the
desired serial port under the list, you may key in the serial port number directly.
Figure 4-2-1 Run AMEC AIS Viewer
You may also clink on
to start the viewer program and connect with the desired serial
port and baud rate in the viewer directly.
1.
Go to “
Connection
”→ “
Connect
AIS
” to set the serial port and baud rate (Figure 4-2-2).
Please refer to
Section 4.3.2.4
“Connect
AIS”
for the details.
2.
If additional information is required from another GPS, please go to “
Connection
”→
“
Connect GPS Receiver
” to set the serial port and baud rate for GPS receiver (Figure 4-2-2).
Please refer to
Section 4.3.2.4 “Connect GPS Receiver”
for the details.
