Amcrest General 1080P(V2) Mini 1U Series, User Manual, Page: 130 / 188

121
Figure 5-21
Please refer to the following sheet for detailed information.
Parameter Function
Mode There are two modes: static mode and the DHCP mode.

The IP/submask/gateway fields are read-only when you
select the DHCP mode to auto obtain the IP.

If you select the static mode, you need to set the
IP/submask/gateway manually.

If you select the DHCP mode, you can view the
IP/submask/gateway from the DHCP.

If you switch from the DHCP mode to the static mode, you
need to reset the IP parameters.

IP/submask/gateway and DHCP are read-only when the
PPPoE dial is enabled.
Mac Address This displays the host MAC address.
IP Version It is to select the IP version. IPV4 or IPV6.
You can access the IP address of these two versions.
IP Address Please use the keyboard to input the IP address and then set
the corresponding subnet mask and default gateway.
Preferred DNS DNS IP address.
Alternate DNS Alternate DNS IP address.
For the IP address of IPv6 version, default gateway, preferred DNS, and
alternate DNS, the input value should be 128-digits. It should not be left
blank.
LAN Download
System can process the downloading data first if you
enable this function. The download speed is 1.5X to
2.0X the normal speed.
5.8.2.2 Connection
The connection interface is shown as in Figure 5-22.