Amcon Auto Chart Projector
14
5.3 Using the program function
1. How to program the Projector
1. Starting the Programming. Getting in the programming mode.
a) Turn on the power switch. The projector goes into initialization state.
b) Press the “RESET” button on the remote control.
c) Press the “R and G filter” button on the remote control.
d) Press the “Reset” button again on the remote control.
The projector will beep twice after pressing each button in “1b, 1c, 1d”. After the
third button, the projector will be in programming mode.
At any time up to step “d”, pressing any other button will return the projector to
normal operating state.
2. Select Program 1 or 2
Press the “P1/P2” switch to select program 1 or 2. The beeper will sound once if
program 1 is selected and twice if program 2 is selected.
3. Selecting Charts for the Program
a) Press the “program up” button to open the position for the first chart.
b) Select the desired chart button along with the desired “highlight” button.
c) Press the “program up” button again to enter the selection and move to open
the next position of the program. The beeper will sound four times. Repeat
steps 3a, 3b, 3c to enter other charts. Up to 30 selections are possible.
