AMCI NEXUS NX2A4E2, User Manual

Page: 47 / 76

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
NX2A4E2 User Manual
S
ET THE
IP A
DDRESS AND
P
ROTOCOL
47
2.2c Use the Embedded Web Server (continued)
2.2c.3 Network Setup Page (continued)
5) If the values are accepted, the following pages will be displayed while the data is being written to the unit.
Wait for the pop up window to appear before cycling power to the NX2A4E2. Cycling power
before this window appears may corrupt the non-volatile memory of the NX2A4E2. The
NX2A4E2 will also flash the Network Status LED red to indicate that power must be cycled.
Figure T2.4 Write Configuration to Flash Memory Pages
6) Once instructed to, cycle power to the unit. You can now enter the new IP address into the address bar of
your web browser to reconnect with the NX2A4E2.
Task Complete
2.2d Use the AMCI NET Configurator Utility
PREREQUISITE: You must know the present IP address of the NX2A4E2. The factory default address is
192.168.0.50.
PREREQUISITE: Task 1.4: Power Wiring found on page 35. You must be able to power the NX2A4E2.
PREREQUISITE: Task 1.5: Network Connections found on page 35. You must attach your NX2A4E2 to
your computer.
PREREQUISITE: Reference 3: Configuring Network Interfaces , found on page 29. The network interfaces
on your computer must be on the same subnet before you can communicate with an NX2A4E2.
2.2d.1 Download the AMCI Net Configurator Utility
The AMCI Net Configurator utility is available on our website, www.amci.com . The latest version available
should be used. It can be found in our Support section under Software . The program exists as a ZIP file, and at
the time of this writing, the link was “AMCI Configuration software for all networked products...”.
2.2d.2 Install the AMCI Net Configurator Utility
Once downloaded, simply extract the program from the ZIP file and run the program to install the AMCI Net
Configurator utility on your computer. The software installs as most products do, giving you the option to
change the file locations before installing the utility. Once the install is complete, a link to the utility is avail-
able on the Start Menu.
The install process only copies the utility to the designated location and creates links to the Start Menu. No
changes are made to your registry settings.
CHANGES TO
ONCE THE WRITE
IS COMPLETED