AMCI ANS1 ANYNET-I/O, User Manual

Page: 70 / 90

Output Data Format
ADVANCED MICRO CONTROLS INC.
5
70
Command Block 11: Program Production Counter Parameters
This block allows you to program the parameters of the production counters.
† These words must equal zero when programming the Machine Revolutions and Good Parts Counters.

(When word 1 equals 4 or 5)
Figure 5.14 Command Block 11
Word 1: Counter Number
This word defines the counter that the rest of the command block programs. The Production Counters sec-
tion of the manual, which starts on page 34, describes the six counters available on the ANS1.
EtherNet/IP
Address
Modbus
Address
Bit Number
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 1024
T
ransmit Bi
t
0 0
App
ly W
o
rds 7
& 8
App
ly W
o
rds 5
& 6
Apply W
o
rd 4
Apply W
o
rd 3
Apply W
o
rd 2
0 0
Delete All
Clear Error
1 0 1 1
1 1025
Counter Number (Range of 0 to 5)
See description below
2 1026
Counter Overflow Output
†
(Range of 0, 1...16)
If ‘0’, no overflow output is assigned to the counter
3 1027 Counter Overflow Mode
†
(Range of 0...2)
4 1028
Batch Counter Increment Mode
‘0’: Counter increments after each complete cycle
‘1’: Counter increments after a cycle without Die Protection Fault
5 1029
Counter Limit Value (32 bit)
†
(Range of 0 to 999,999,999 [0x0000 0000 to 0x3B9A C9FF])
6 1030
7 1031
Counter Preset Value (32 bit)
(Range of 0 to 999,999,999 [0x0000 0000 to 0x3B9A C9FF])
8 1032
9-19 1033-1043 Not Used
Counter Number
(Word 1 Value)
Counter
0
Part Cycle Counter. This counter increments based on the Production

Cycle Multiplier and Divisor values.
1 Batch Counter 1
2 Batch Counter 2
3 Batch Counter 3
4
Machine Revolutions Counter. This counter increments every machine

cycle.
5
Good Part Counter. Counter increments with the Part Cycle Counter if no
die protection faults occurred during the part cycle.