Installing the ANS1
ADVANCED MICRO CONTROLS INC.
4
38
Module Installation (continued)
Module Mounting
Dimensions
Below is an outline drawing compatible with the ANS1 module.
Figure 4.1 ANS1 Outline Drawing
Compatible DIN Rail
The ANS1 along with an RB-7 or RB-8 relay board can be mounted on following DIN rail:
EN 05 022 - 35 x 7.5 (35 x 7.5 mm)
If you are only installing one ANS1 module instead of an interconnected stack, then you can also use the fol-
lowing DIN rail:
EN 05 022 - 35 x 15 (35 x 15 mm)
The EN 05 022 - 35 x 15 DIN rail is unacceptable when installing multiple AnyNET-I/O mod-
ules as a stack. The IC-5 connector that is used to interconnect the modules requires the EN 05
022 - 35 x 7.5 DIN rail for proper operation.
The DIN Rail must be securely mounted to a panel and solidly grounded before the module is installed.
Grounding is usually accomplished through the mounting hardware, by first removing any paint or other
material from all surfaces that may interfere with proper grounding. Another option is to install a heavy
gauge wire from the DIN rail to your system’s ground bus.
4.47"
(113.5)
5.10"
(129.5)
3
.90"
(99.
1)
4.
55
"
(1
1
5.
6)
1.78"
(45.2)
I/O Mating Connector
0.26"
(6.6)
ADDRESS
PLS
PWR FUSE
IN
OUT
09
09
13
13
10
10
14
14
11
11
15
15
12
12
16
16
ADDRESS
PLS
PWR FUSE
IN
OUT
09
09
13
13
10
10
14
14
11
11
15
15
12
12
16
16
Summary of Contents for ANS1 ANYNET-I/O
