Version 1.0
©Copyright 2017, Ambient LLC. All Rights Reserved.
Page 8
5
Console Operation
Note:
The console has three buttons for easy operation:
MIN/MAX/-
button,
SET
button, and
CH/+
button.
5.1 Min/Max Mode
The Min/Max mode displays the minimum and maximum temperature and humidity (since reset of the
unit) for the indoor, remote channel 1 through 8 sensors.
Prior to entering the
MIN/MAX
mode, press the
CH/+
button to select the temperature and humidity
values you wish to view.
1.
Display Maximum. Press the MIN/MAX button once to display the maximum. The
icon will be displayed.
2.
Clear Maximum.
To reset the maximum values to the current values, press and hold the
MIN/MAX
button for 3 seconds.
3.
Display Minimum. Press the MIN/MAX button again to display the minimum. The
icon will be displayed.
4.
Clear Minimum.
To reset the minimum values to the current values, press and hold the
MIN/MAX
button for 3 seconds.
To return to normal mode, press the
MIN/MAX
button again.
5.2 Clearing Min/Max Daily
The minimum and maximum can be set to clear daily (every 24 hours automatically) or manually.
Press and hold the
SET
button for 3 seconds to switch between
and Clears Manually.
When you manually clear the minimum and maximum, the Clears Daily function will clear every 24
hours from the time you clear it.
For example, if you clear the min and max at 4:00pm, it will continue to clear every day at 4:00pm.
5.3 Backlight Operation
To temporarily turn on the back light for five seconds, press the
any
button on the indoor sensor.
5.4 Indoor/Outdoor Channel Selection
Press the
CH/+
button to switch the display between the indoor temperature and humidity
,
remote sensors 1 through 8, and scroll mode
. In scroll mode, all of the indoor and detected
outdoor sensors will be displayed in five second intervals.
5.5 Temperature Units of Measure
The default temperature units of measure are degrees Fahrenheit. To toggle between degrees Celsius
and degrees Fahrenheit, press and hold the
MIN/MAX
button for 3 seconds.
5.6 Sensor Search Mode
If any of the sensor communication is lost, dashes (--.-) will be displayed on the screen. To reacquire
the signal:
