ACL204
experience quality
.
Rev. 4.10
www.ambient.de/en
13
Level
Select TC level:
0
/-3/--6/-9/-12/-15/-18/-21/-24/-27/-30/-33/-36/-42 dB
Only available for ACN-TL Tiny Lockit
Adjusts TC level on Lemo B in -3dB steps from
0
to
-36dB
plus
-42dB
. Useful when recording TC on audio
tracks of DSLRs or non-TC capable recorders.
Mute
Mute on Gen Not Set:
No
/Yes
Disable the physical output of timecode in case the generator is not set (flashing red) in int TC and C-
Jam modes. This can be useful to leave the Lockit connected to your audio recorder with a bidirectional
cable and jam it to time of day from the recorder after start up and then seamlessly becoming the
timecode source. Also with no TC output most cameras will display a warning in the viewfinder monitor
which provides immediate visual troubleshooting.
Note: No TC is as good or bad as inconsistent TC, therefore there is no drawback to have the
output muted. Rather, it will give you better indication if setup is not complete/correct.
Offset
Offset: +/-00.00
Extended Setting
Shifts the TC output up to +/- 10 frames in .05 increments on both Lemos and LED display on ACN-LS
Lockit slate against the generator. This allows for compensation of frame processing delay on cameras
and TC offset to 3
rd
party equipment (e.g. delayed TC out from audio track on playback).
UB
↑
Show (t)
Jam
Edit
Show
Toggles userbits to be displayed in main screen, will reduce the font size of TC.
Jam
On
Off
“On”
: Userbits will be jammed on change. This will happen on TC Jam but also on every change without
the TC generator being interrupted. When C-Jam is enabled this can be used to increment scene/take
on the fly via ACN.
Note: Update will occur with up to 6 seconds delay on the next C-Jam broadcast.
“Off”
Userbits will be locked. Use this mode to apply a fixed ID through userbits.
Edit
Allows manual changes to userbits on the fly, enter 8 UB digits with hex-code values 0-F. On changing
existing UB value a prompt will pop up to confirm or discard the new value. This will override the
current value but not change jam mode itself. So, for static ID set Jam to “Off”
