Scheduled Event List
This page shows the scheduled timed events in the
playlist (see
section). When you first install
your receiver, this will have no entries as shown below.
Action is the type of event that will happen.
Time is time and/or date when the event will happen.
Source is what file or program will be played.
Target is where the output has been addressed.
Level shows how much the signal has been attenuated by showing its relative volume. A
setting of 0dB means there is no attenuation and a reading of –inf means it is
completely off.
Ramp shows the fade listed in playlist file for that file or event. It shows how many
seconds of fade the program will have at the end of the file.
Output Target shows you which output Port
is being used
State shows whether the output is active or not. When it is blank, the output is not being
used for that action and a “1” means the output is active.
The following shows several files and they begin playing 23:32:30 local time or the time
on the receiver as determined by the
setting.
The column labeled Action has the following entries:
OPEN/SEEK is when the AMR-100-I “cues” the file. It does that one second before it
plays.
PLAY shows that it will play at 01:30:00.
STOP shows when the file will end at 01:52:00.
Rev. 1 – Firmware version 2.03
41
©
2012