*RpPort/LdPort: 25000 This is always 25000.
If you change this port number, your
receiver will not communicate with the AMB-OS servers
.
The process for changing the port is the same for all eight ports. Scroll down to the port you
want to change and press [ENTER]
1. Press [ENTER] to select 2
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] to move to the next one
4. Press [BACK] to return to a previous digit to correct it
5. Press [ENTER] to go to each digit. When you press [ENTER] at the last digit, it will
save your new port number and return to the IP Address submenu
*CmdAddr: 239.239.239.128 (This should never be changed unless instructed to do so by
Amb-OS support personnel. It is the port used to send commands to the AMR-100-I
receiver.
Remember 1 and 2 digit subnet addresses have leading 0’s (.002. for .2. and .
030. for .30.).
1. Press [ENTER] – First digit is selected
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] when have the number you want (it will move to the next digit)
4. Press [UP] or [DOWN] to select next digit
5. Press [BACK] to go back to the previous digit to correct it, if necessary
6. Do this for all 12 digits, then press [ENTER] to save and return to the IP Address
submenu
*CmdPort: 23456 (This should not be changed unless instructed to do so by support
personnel. If you change this port number, your receiver will not accept commands.
1. Press [ENTER] to select 2
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] to move to the next one
4. Press [BACK] to return to a previous digit to correct it
5. Press [ENTER] to go to each digit. When you press [ENTER] at the last digit, it will
save your new port number and return to the IP Address submenu
*WebPort: 80 (Normally, this does not need to be changed..) If you have multiple web access
pages at your location, you may need to change this. You change this port number
through ‘html’ interface – see the
section.
1. Press [ENTER] to select 0 – the display will change to 00080
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] to move to the next one
4. Press [BACK] to return to a previous digit to correct it
5. Press [ENTER] to go to each digit. When you press [ENTER] at the last digit, it will
save your new port number and return to the IP Address submenu.
6. To change the port to 8080
a. Press [ENTER] at the first 0 to move to the second 0.
b. Press [UP] to change the number to 8 – the display will read 08080
a. Press [BACK] to save the setting
Rev. 1 – Firmware version 2.03
29
©
2012