one or two digit subnet addresses should have leading 0’s. For Example: 192.168.1.20 should be
entered as: 192.168.001.020.
IP Address Change
1. Press [ENTER] and you will see a menu bar with
“Setup” highlighted.
2. Press [ENTER] then press [DOWN] until “IP
Addr: DHCP” is highlighted; then press
[ENTER].
3. Press [DOWN] until “DHCP” is highlighted; then
press [ENTER] to select “NO” as the option.
“NO” and “YES” are the only two options
4. Press [BACK] to save that setting.
5. Press [DOWN] until “IP Addr:” is highlighted;
then press [ENTER]. The first digit will be
highlighted as seen in the figure to the right.
6. Press [UP] or [DOWN] until you get the first digit
correct and press [ENTER]. That will take you to
the next digit. Repeat this step until you have the desired IP address. You may press
[BACK] to return to a previous value that was entered incorrectly. The last digit’s
[ENTER] command will exit the address-setting dialog.
7. Press [DOWN] to highlight “Gateway”.
8. Using the method as described in #7, enter the gateway IP address.
9. Press [DOWN] to highlight “Netmask”. If the default (255.255.255.0) is correct for your
local network, press [BACK] to save any previous changes or wait approximately 15
seconds for any changes to be saved automatically. If the default values are not correct
for your local network repeat the method as described in #7 above until the Netmask is
correct. After selecting the last digit, pressing [ENTER] will exit the Netmask setting
dialog and once again highlight “Netmask”. Now you may manually press [BACK] to
save any changes made or wait approximately 15 seconds for the changes to be saved
automatically. The remaining IP menu items (“Server1” and all after) do not need to be
changed at this time.
With the correct IP address, Default Gateway and Subnet Mask entered, you can run the supplied
program to create playlists, transfer files and play programs.
Rev. 1 – Firmware version 2.03
20
©
2012
Firmware: 2.03
Serial No: 2001000
IP Addr: DHCP
T
Clock Interval
Date
DHCP:
NO
IP Addr:
1
92.168.001.100
Gateway:
1
92.168.001.001
Netmask:
2
55.255.255.000
Setup
WARNING
If you put in an IP address manually, you must also put in the subnet mask
and the default gateway. If not, you cannot exit the IP Address menu.