NOTE
Operating conditions such as the grain shape,
dressing or the addition of talcum affect the
correct selection of the singling discs. The
selection of the singling discs width must be
adapted to the respective operating conditions
and can only be determined during field
operation.
The sliding shutter position and fan pressures are
reference values. Check the grain placement after
driving a short distance.
1. The setting parameters can be found in the table.
2.
To adjust the grain singling,
see "Adjusting the grain singling unit".
3.
To adjust the PreTeC coulter,
see "Adjusting the PreTeC coulter".
6.4.8 Adjusting the fan speed via the hydraulic system
REQUIREMENTS
The seed hoppers are filled
The implement is unfolded
The fan is switched on
The singling discs are filled with seed grains
DANGER
Risk of injury due to parts of the fan being
flung out
If the fan is operated at excessive speeds,
fan parts can break and be flung out.
Make sure that the fan speed does not
exceed 5000 rpm.
The fan speed changes until the hydraulic fluid has
reached its operating temperature.
Depending on the equipment, a pressure gauge,
control computer or control terminal shows the air
pressure. The specified fan pressures are reference
values. Check the grain placement after driving a
short distance.
CMS-T-00005826-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6967-EN-II | C.1 | 27.09.2021
78
