6.4.25.6.2 Disconnecting the energy supply
1. Disconnect the ISOBUS from the tractor.
2.
To deactivate the coulter,
disconnect the coulter wiring harness
1
from
the implement wiring harness
2
.
3. Connect the implement wiring harness to the
bridge plug
3
.
4. Seal the coulter wiring harness
1
with a dust
cap.
CMS-I-00003830
6.4.25.6.3 Disconnecting the hydraulic supply
1.
To unfold the implement,
see "Unfolding the implement sections".
2.
To set the coulter pressure to zero,
refer to the ISOBUS operating manual, "Adjusting
the coulter pressure".
3. Lower the implement and move the three-point
hydraulic system of tractor into float position.
The coulter pressure cylinders retract and the
coulter pressure is relieved.
4. Switch off the fan.
5. Secure the tractor and implement.
6.
To relieve the residual pressure from the
hydraulic coulter pressure system,
connect the hydraulic plug
1
to a pressureless
return flow line.
CMS-I-00004129
CMS-T-00005474-B.1
CMS-T-00005478-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6967-EN-II | C.1 | 27.09.2021
157
