1.
Raise the implement.
2.
Release the linch pin
2
.
3.
Hold the wheel mark eradicator by the recessed
grip
1
.
4.
Remove the locking pin
3
.
The maximum working depth is 150 mm.
5.
Move the wheel mark eradicator to the desired
position.
6.
Secure the wheel mark eradicator with the locking
pin.
7.
Secure the locking pin with the linch pin.
8.
To check the setting,
drive for 30 m at working speed and then check
the work pattern.
1
2
3
CMS-I-00000942
6.5.9.2 Adjusting the wheel mark eradicator to the track width
REQUIREMENTS
The implement is raised
The tractor and implement are secured
Tightening torque: 160 Nm
1.
Release the clamp connection
1
.
2.
Move the wheel mark eradicator bracket
2
to
the desired position.
3.
Tighten the clamp connection.
1
1
CMS-I-00001908
CMS-T-00001930-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6149-EN-GB | J.1 | 18.10.2022 | © AMAZONE
84
Summary of Contents for Precea 4500-2
Page 255: ......
