6.5.2 Adjusting the working position sensor
The working position sensor monitors the implement
position in the three-point hydraulic system and
switches the metering drives. The lever length is
adjustable.
1.
loosen the nut
1
.
2.
Place the lever
2
on an level contact surface on
the top link
3
.
3.
Tighten the nut.
4.
To ensure that the working position sensor is
resting on a level surface,
completely lift and lower the implement.
5.
To configure the working position sensor,
refer to the ISOBUS software operating manual,
"Configuring the working position sensor"
or
see "control computer" operating manual.
1
2
3
CMS-I-00002608
6.5.3 Filling the seed hopper
REQUIREMENTS
The implement is coupled to the tractor
The tractor and implement are secured
The seed and seed hopper are free of foreign
objects
The seed is dry and does not stick
IMPORTANT
Leaks in the hopper cause faulty
placement
Do no walk on the hopper cover.
Keep the cover seal and sealing surface
clean.
1.
Open the fastener
2
.
2.
Press the hopper cover
3
down.
3.
Unlock the
1
fastener.
1
3
2
CMS-I-00001886
CMS-T-00003625-E.1
CMS-T-00001914-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6149-EN-GB | J.1 | 18.10.2022 | © AMAZONE
65
Summary of Contents for Precea 4500-2
Page 255: ......
