6.5.25.3 Adjusting the row spacing between 75 and 45 cm
CAUTION
There are crushing and shear points
between the implement sections and the
implement.
When folding or unfolding the implement
sections,
never reach into the crushing area.
NOTE
Telescopic frames with the long protrusion
1
can
be telescoped from 75 to 45 cm.
CMS-I-00003844
1.
Raise the implement.
2.
To set the row spacing to 45 cm,
telescope the implement in.
To set the row spacing between 50 and 75 cm, the
linch pins
1
must be positioned between the rows.
3.
Remove the linch pin between the first and
second coulter.
4.
Move the linch pin in the slotted link
2
to the
desired position between the first and second
coulter.
5.
Move the linch pin in the slotted link to the desired
position between the second and third coulter.
6.
Move the opposite linch pin in the slotted link to
the desired position between the fourth and fifth
coulter.
7.
Move the opposite linch pin in the slotted link to
the desired position between the fifth and sixth
coulter.
CMS-I-00003839
CMS-T-00005412-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6149-EN-GB | J.1 | 18.10.2022 | © AMAZONE
147
Summary of Contents for Precea 4500-2
Page 255: ......
