6.2.8 Operation without front hopper
If the implement should be used without the
front hopper,
install the terminating resistor
1
on the signal
cable
2
for the front hopper.
CMS-I-00005657
6.3 Preparing the implement for operation
6.3.1 Adjusting the working position sensor
The working position sensor monitors the implement
position in the three-point hydraulic system and
switches the metering drives. The lever length is
adjustable.
1.
loosen the nut
1
.
2.
Place the lever
2
on an level contact surface on
the top link
3
.
3.
Tighten the nut.
4.
To ensure that the working position sensor is
resting on a level surface,
completely lift and lower the implement.
5.
To configure the working position sensor,
refer to the ISOBUS software operating manual,
"Configuring the working position sensor"
or
see "control computer" operating manual.
1
2
3
CMS-I-00002608
CMS-T-00008281-A.1
CMS-T-00003741-D.1
CMS-T-00003625-E.1
6 | Preparing the machine
Preparing the implement for operation
MG6659-EN-GB | F.1 | 25.10.2022 | © AMAZONE
53
