Amazone KE 3002, Original Operating Manual

Page: 103 / 120

9.3 Eliminating faults
Errors Cause Solution
The trailing roller rotates stiffly
during initial operation. Production-related paint residues
make it difficult for the roller to
rotate. Pull the roller over firm ground.
Tines stopping during operation If the tines encounter an obstacle,
the tool carriers are blocked. see page 98
After the tines have encountered
and obstacle, the obstacle is
jammed between the tines. The
ratchet clutch does not engage
automatically. see page 98
The ratchet clutch is often triggered Maintenance required on the
ratchet clutch.
see page 98
Excessive torques on the ratchet
clutch. see page 99
The track marker collision
protection is triggered. The track marker has encountered
a solid obstacle. The shear bolt is
torn and the track marker folded to
the rear. see page 99
The wheel mark eradicator does
not reach the desired working
depth. When the worn tine has been
replaced, the working depth of
the soil tillage implement must
be corrected. The wheel mark
eradicator brackets are too high
above the soil see page 100
The wheel mark eradicator tool
carriers are constantly working in
the soil horizon. Due to wear on the rotating tines,
the working depth of the soil tillage
implement must be corrected. The
wheel mark eradicator brackets are
too close above the soil. see page 101
The lighting for road travel has a
malfunction. Lamp or lighting supply line is
damaged. Replace the lamp.
Replace the lighting supply
line.
It lowers the wrong track marker. When actuating the tractor control
unit, the wrong track marker is
lowered. Switch the control unit several
times.
The tension spring of the wheel
mark eradicator is broken. To install and remove
the tension springs, contact
Customer Service or your
dealer.
CMS-T-00004633-B.1
9 | Repairing the machine
Eliminating faults
MG6878-EN-II | D.1 | 18.05.2021 97